AY Products

PROTECT AUSTRALIA'S FISHERIES INDUSTRY

This POWERFUL, Bio-Degradable Anti-Foul will give under water protection from fouling – Plus General Rigging and Prop Protection against Oxidization, Electrolysis Barnacle Encrustation on your vessel for up to 6 to 8* months.

Suitable for:

Propellers, Prop Shafts, Rudders, Trim tabs, Out drives, Compatible with bronze, stainless steel, aluminum and paint

	AYMGI 'Formula' is the ideal marine coating because of its proven ability to resist acid etching.
	Subsequent reapplication requires no special hull treatment such as sanding / grinding etc.
	AYMGI 'Formula' Marine Coating will virtually eliminate electrolysis—a little spray will stop this problem.
	AYMGI 'Formula' will in most cases provide a drag co-efficient reduction on high speed vessels such as passenger cat ferries etc.
	This drag reduction allows the vessel to slip through the water much easier, this then reduces fuel usage which will benefit the operator of the vessel significantly.

Preparation & Application:

	All vessels which has been in seawater, should first be washed with liquid chloride (Ratio 3:1).
	This is to ensure any microscopic spores are killed / removed.

For previously Anti-Fouled Hulls:

	Marine growth of any type and residual anti-foul must be removed.
	Surface must be touch dry before application.

2 types of application is possible:

	Roller or Brush application. AYMGI must be soften or melted by using either hot water to warm the tub or a hot (flat) frying for Roller application.
	A manual spray or compressor style may be used.

Reapplication:

	Hot pressure washer / Steam cleaner.
	Surface blasting or hand washing.
	Water temperature must be above 60 degrees Celsius.

Maintenance:

	Static / Moored Hulls must be inspected every 4 to 8 weeks.
	Depending on water, tidal, area conditions.
	Marine growth can vary according to the environment. Hull may be wiped down, thus leaving the AYMGI attached to the surface .
	12* to 15* months shelf life on vessel.

*Environment conditions play a vital role in fouling of any vessel.

Aluminum Hulls:

	Surface must be clean and Dry.
	Aluminum cleaner may need to be used for any heavy oxidization.
	Then apply AYMGI according to application description.

Fiberglass Hulls:

	New / Untreated Hulls will require a Gelcote Sealer.
	Surface must be Clean and Dry.
	No reported instance have been reported as to reactions with Gelcote.
	If unsure, test in an inconspicuous area for reactivity.

Take the first step today in making the worlds waterways a better place, both for future generations and us.

In our opinion Chemical / Petroleum based Anti-Fouls DO NOT BELONG in our Waterways!

Neither should they need to be applied to:

Fishing Trawlers

Oyster cages *

Mussel barges *

Lobster nets *